If your terminal is connected and configured properly you should get a prompt similar to: “WebMon>” after the power up sequence is complete (or any time you hit the “Enter” key).(For more information on terminal software setup and usage see the Dante! SSG document “ASCII Terminals”.) The communication settings are: 9600 baud, 8 data bits, l stop bit, No Parity, and No Flow Control.The WebMon will do a reset and come up in about 30 seconds using the new IP data. Hit “Y” and then hit “Enter” to confirm that you do wish to perform a soft reset.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |